Steel and Metals

Weldon Twist Drills DoC 50mm Diameter 7mm HSS 19,05mm Weldon shank Available in 30 mm and 50mm length, DoC 135 Degrees split point Machined from one solid blank - no weak spots caused by inferior material or welds DRILL LENGTH: 50mm

Weldon Twist Drills DoC 50mm Diameter 9mm HSS 19,05mm Weldon shank Available in 30 mm and 50mm length, DoC 135 Degrees split point Machined from one solid blank - no weak spots caused by inferior material or welds DRILL LENGTH: 50mm

HSS-G - Fully ground – 118 Degrees split point This Drill Bit set contains 25 Fully Ground High Speed Steel HSS-G twist drills with a 118 Degrees point angle for drilling in non-ferrous metals, mild steel and cast iron Sizes 1 to 13mm with 0.5mm increments The drill bits consist of a 3-flats shank – 4mm and up The high performance cutting edge ensures a...

Professional Industrial HSS Ground Bright Ground from solid high speed steel Type N, straight shank, jobber series Right-hand cut, with 135° split point tip, good true-running properties Excellent for non-ferrous metals which do not cold weld For drilling in commonly used materials up to approximately 1200N/mm² strength Such as steel and steel castings,...

Standard Point is suitable for general purpose drilling Roll Forged High Speed Steel (HSS), Type N Straight Shank, Jobber Series Right hand cut with 118° point angle Special steam-initiated surface treatment For drilling in commonly used materials up to approximately 900 N/mm² strength Such as steel and steel castings and plastics where the cutting...

PROFESSIONAL HSS Double End Stub Ground from solid high speed steel Double-ended twist drill without chamfer, right-hand cut 135° split point tip reduces end thrust and optimizes centre cutting efficiency Recommended for hard and high strength materials Special steam initiated surface treatment For drilling holes in sheet metal, tubular sections and...